Skip to main content
Print

Alert Action Triggers

Run a control action from an alert

An alert can trigger a configured device output when its condition occurs. Configure the alert rule and its recipients separately from the control action.

Prepare the action

  1. Confirm the intended device, supported control and permitted operating response with the responsible installer or Technician.
  2. Open the alert configuration and enable its available control-action option.
  3. Select the intended supported output and value, then review the rule, execution mode and notification settings before saving.

Use the correct device manual for writable values, register behaviour and electrical installation. A portal control can affect operating equipment; do not use an arbitrary value or another model’s reset command.

Check execution and recovery

A cloud action depends on cloud connectivity. On Glacier, choose Edge explicitly where supported for local execution during internet loss; power and an active licence remain necessary. Missed cloud scheduler actions are not replayed after reconnection. Ask Polar support about retry and reconnect behaviour for the specific alert action. Physical commissioning and restart/output behaviour require an agreed installation-specific procedure.

See alert setup, control buttons and schedulers.

Table of Contents