Skip to main content
Print

Troubleshooting Ethernet Gateways

Troubleshoot a Polar Ethernet connection

Separate gateway-to-cloud connectivity from gateway-to-device communication before changing settings.

If the gateway is offline

  • Check the gateway is powered using its correct hardware manual. Use that manual for electrical ratings, wiring and indicator patterns.
  • Check the Site licence is active and gateway/device status in Polar. Licence suspension can stop service.
  • For LTE/Ethernet gateways, Link A indicates cloud connectivity; use the correct model manual for all other indicator meanings.
  • Check that the Ethernet cable is connected and undamaged, and have the network administrator confirm the intended LAN has internet access.
  • Record any relevant network changes. Do not disable security controls or invent firewall/port rules; coordinate with the network administrator and Polar support.

If the gateway is connected but device data is missing

  1. Confirm the correct device type and address/Slave Id in Polar.
  2. Have the installer compare the actual device serial protocol/settings with the required gateway configuration; use the applicable device-specific manual.
  3. Check the approved RS-485 polarity, cable, termination/reference/isolation arrangement. Do not improvise ground connections.
  4. If several devices share the bus, have the installer isolate the fault under an agreed procedure rather than interrupting an operating system without planning.

Record and escalate

Give support the gateway/device identifiers privately, Site name, power/Link A state, portal status, time the problem started and recent changes. Keep serials and personal information out of public screenshots. Ordinary LTE/Ethernet gateways have no local data buffer, so missing readings are not recovered merely by reconnecting.

Gateway setup · Site licence checks.

Table of Contents