Skip to main content
Print

Link a Device to your Gateway

Link a monitored device to your gateway

Link the gateway to the intended Site before adding its monitored devices.

  1. Expand the Site and choose Add Device.
  2. In the demonstrated Link Device dialog, choose the gateway and Device Type.
  3. Set Slave Id to match the address configured on the actual equipment.
  4. Enter a meaningful Device Name and Description.
  5. Choose Link Device.
Link Device fields for an integrated meter. The gateway identifier is redacted.
Link Device fields for an integrated meter. The gateway identifier is redacted.

The demonstrated serial Modbus network uses 9600 baud, 8 data bits, no parity, 1 stop bit (8N1). Match the attached equipment to those settings and the configured Slave Id. This serial example is not a universal configuration for every Glacier port or TCP device. Select Generic Modbus if no integrated driver is available; register mapping then requires the correct device documentation and specialist setup.

For Group/Site setup and the Glacier Serial/TCP distinction, see the complete installer setup guide.

Table of Contents