Skip to main content
Print

Adding Devices on the EMS Portal

Add a device through Glacier Edge

This is the common portal-linking route for Glacier/EMS equipment, not a revision of any inverter, meter or controller manual. Configure the actual device according to its unchanged model-specific guide.

Before you start

  • Account, customer Group, Site and linked Glacier gateway are in place.
  • The device integration or Generic Modbus mapping is identified.
  • The approved installation network plan, physical COM port or IP address and device address are known.

Link the device

  1. Open the Site and choose Add Device.
  2. Select the Glacier gateway, integrated Device Type or Generic Modbus, then enter a meaningful name/description.
  3. For Serial, choose the wired isolated COM port and matching Slave Id/settings.
  4. For TCP/IP, choose TCP/IP and use the approved installation address and port 502, with device-specific settings as required.
  5. Choose Link Device and review its status and dashboard.

Use the approved address plan

Do not copy an arbitrary address from a tutorial. Avoid duplicate, gateway, reserved or broadcast addresses and confirm the plan for that installation.

Table of Contents