fbpx
How can we help?
< All Topics
Print

Wiring the Polar Gateway to a DSE controller

This guide will show you how to connect the Polar Monitoring Gateway to the Deep Sea Electronics DSE controller. It will also take you through how to setup and change the parameters required on the device to ensure communications to the Polar Gateway.

Steps to follow:

  1. Connect power to the Gateway.
  2. Connect RS-485.
  3. Final checks.
  4. Power on the system.
  5. Configure the DSE Serial Parameters
 

DSE Connection Setup

DSE 7310 - Wiring Diagram
Wiring Diagram
1. Connect power to the Gateway.
Power Polar Gateway

Connect the gateway to a 12-24 V DC power supply. Connect the positive wire to the positive outlet and the negative wire to the negative outlet.

2. Connect RS-485
DSE 7310 RS-485

Connect the Modbus cable to allow communication with the polar gateway device. Connect A+ => A and B- = B.

3. Final checks
Before you switch on the device make sure you have done everything correctly in the previous steps.
 
  • Make sure the power is OFF while doing the cable wiring.
  • Re-check if there are no short circuits.
  • Check if the power cables are not loosely wired to the Gateway.
  • Check if the power cables are not loosely wired to the Generator Controller.
  • Re-check the RS-485 twisted pair cables is correctly connected A+ => A and B- = B.
4. Power on the system.

Now you are ready to go, you can now switch on the power to make some configuration changes for your Polar Portal. 

5. Configure DSE Serial Parameters
In order for the Gateway to correctly communicate with the DSE controller, there will need to be some changes made to the communication parameters. 

To change the parameters of the DSE Controller, you will need to use the DSE Configuration Suite software, the button on the right will take you through the installation and configuration process.

6. Click to button on the right to setup your device on the PolarPortal…
Previous WEG CFW500 Variable Speed Drives
Next Wiring the Polar Gateway to an APM303 generator controller
Table of Contents
Copyright © 2022 Polar Monitoring